The versatility of Pneumatic high stress grouting pumps

Peumatic Grouting pump is designed for stress and filling grouting of cement and bentonite slurries. It is primarily used for injecting (grouting) bar anchors and the drill holes so as to reinforce the loose rock mass. The most grain size can not exceed zero.2 mm.
Grouting pump operation and maintenance is simple, protected and reliable. This pump is used in mines operating underneath troublesome situations as a outcome of it is dependable and explosion-proof.
Basic Pneumatic Grouting pump embody: An air inlet, the pneumatic cylinder, mounting base frame and stand, strain gauge, pumping cylinder, outlet with fast release coupling and wheels.
How it actually works
Pneumatic stress within the air cylinder exerts a excessive pressure on the grout mixture which finally ends up in ejection of grout with a high stress and velocity. The valves of the air cylinder within the pump perform mechanically to actuate the cylinder. The pneumatic cylinder then moves the plunger up and down to finish the pumping cycle.
Pneumatic grout pump may be driven even without Electrical energy provide in distant areas by utilizing engine pushed compressor.
The pump is majorly utilized in building and mining business for injecting material into broad and medium measurement gap in beams, columns ,basement walls and flooring, lift shaft concrete wall fill-up etc. In mining industry it is used to refill cement solution the place there’s a gap exists between construction and rock and for soil stabilization.
Detachable design tends to simple upkeep and transportation. Challenging works like Grouting in Bridges.
READ: How hydraulic submersible pumps work
This pump is widely utilized in tunnels, coal mine, bridges and dams, constructing foundation, and other underground initiatives, and inflammable, explosive websites and other dangerous environment.
It has application in chemical business additionally to pump out chemical slurries.
The pump is electricity free so, can be utilized at any website condition whether it’s rural or urban.
Mining Pneumatic Grouting pump has a bigger discharge slurry adjustment vary. Generally the final quantity of the grouting quantity is eight or10 times of the amount at first. And the final grouting quantity proves that filling is compacted.
Simply put; Pneumatic high-pressure grouting pump is specifically designed for high-pressure grouting. And it adopts full hydraulic drive, it’s strain and circulate may be adjusted based on the requirements of grouting,(The flow of grouting pump is 0-100L/min, strain of discharge is 0-10MPa).in addition to, This Pneumatic high-pressure grouting pump can be used for grouting single or double fluid.
High-pressure grouting pump is principally used for highways, railways, water and electrical energy, building, mining etc. ground/underground construction.
Mining Pneumatic Grouting pump has the advantages of low power consumption, small vibration, low noise, small dimension, excessive effectivity, dependable performance, strain and circulate control, long life and so forth. Common mine grouting pump has pneumatic injection pump, twin fluid injection pump, extrusion injection pump and piston injection pump.
Pneumatic grout pump can be Light weight and with a wheelie design it may be carried simply. เครื่องมือความดัน is designed for easy operation and low maintenance. Last but not least its spare components are simply available.

Leave a Comment